JBL 2022H PDF
JBL H (8Ohm). Unavailable. Category of diameter 12 inch / cm; Znom 8 ohm; Weight volume is not set, then delivery by plane is not possible. Brand New JBL H 12″ Aftermarket Recone Kit, 8 ohm. Parts specifications: Cone: 12″ outside diameter, ″ deep, ″ voice coil opening; Voice. Subwoofer JBL H. General specifications: diameter 12 inches, maximum power W. Thiele-Small parameters: frequency of self resonance Fs=75 Hz, .
|Published (Last):||19 June 2017|
|PDF File Size:||9.69 Mb|
|ePub File Size:||15.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
Logged If we knew what the hell we were doing, we wouldn’t call it research would we. I’m not aware of it ever being used in a 3-way app as a mid driver.
It sounds to me that you would prefer the ‘s over ‘s for mid use. Ie putting a kit in an E and so forth. Another question, can the be reconed to the specs better LF handling? The letter suffix represents the impedance, not frequency range of the speaker. I 202h under the thought that the suffix was also something that showed intent or use of the driver eg- a single driver with a 16ohm impedance would be used for a total 3 or 4 way system impedance of 8 ohms, but a single 4 ohm driver 20022h be used for a 2 way system impedance of 8 ohms This yields an Xmax of only 0.
February 18, It’s really a mid-range, a mid-bass at best. The is also its own, it is an underhung design with a gap depth of 13mm. Read times Brian Elstro Jr.
The is all its own and is even less a woofer, it’s dynamite about Hz and above. Please login or register. Write a poem to a friend, even a lousy poem. Extra 2022hh by vBulletin Hispano. February 24,ubl None were specifically for “mid range”. Basically the K, K, and shared the same magnet structure, including the top plate.
It has been quite a few years since I was doing reconing-but I remember that the magnet thickness was different between them. All that being said, my original post was pre-emptive of checking the VC, which didnt seem to be effected at all. Do what Tim recommended and give Charlie Tappa a call.
JBL H 12 inch speaker unit on | Alibaba Group
February 21, My name is Scott, as in give me more power Scottie!! Results 1 to 5 of 5. The kit is the same cost as a H. Logged “can you make them sing better? From what I’ve been able to understand, is that the is JBL’s new king of midrange February 19, For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as 2022n as I could.
Do it as well as you possible can. However the magnet structures and magnetic energy focusing are different-so you will end up some sort of “half breed”.
In most cases-similar older JBLS can be reconed “kinda” as different model. One starting point in my confusion I read that someone re-coned a to aincreasing x-maxx how The differences in a 12″ driver in a 4 way system vs its 2-way sibling’s frequency response would be a huge factor, right?
Ivan Beaver on February 19, Differences were achieved in cone composition, coil windings, and VC former material.
Dance to the radio. This message comes from JBL Dog.
Hi subwolf, thanks for the info. Last edited by maxwedge; at There was a ridge left behind from the old dustcap glue so I had to score the new cone near the former to get it to 202h down flat, but once all the pre-fit was done, glue-ing it in wasnt too big of an issue rubber cement The x came jb, 3 versions listed below.
I don’t know anything about the The rip went all the way around the dust cap which made me think that I had totally blown itand at one point into the middle of the cone. I’ll leave the flame suit on for this All times are GMT Generally it will be more like the kit you put in it than the original-but will not have the exact same performance. The letter following the is used to designate the impedence.
Brian Elstro on February 18, Is it worth while to recone? Ditto E, E, and