ASTM B316 PDF
ASTM B/BM: Standard Specification for Aluminum and Aluminum-Alloy Rivet and Cold-Heading Wire and Rods. See the chemical composition and physical properties of ASTM B Grade O Wrought Aluminium, find alternative materials, and connect with suppliers . See the chemical composition and physical properties of ASTM B Grade T6, find alternative materials, and connect with suppliers.
|Published (Last):||23 February 2006|
|PDF File Size:||2.29 Mb|
|ePub File Size:||12.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
For heat-treated tempers, an inspection lot shall consist of an identifiable quantity of material of the same mill form, alloy, temper, and nominal diameter traceable to a heat-treat lot or lots, and subjected to inspection at one time. One tension test per specimen shall be taken.
Historical Version s – view previous versions of astj. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
ASTM B Gr Aluminum Rod at Rs /kilogram | Aluminium Rod | ID:
Throughout this specification the use of the term alloy in the general sense includes aluminum as well as aluminum alloy. On the other hand, an inspection lot shall consist of an identifiable quantity of material of the same mill form, alloy, temper, and nominal diameter subjected to inspection for b16 heat-treated tempers.
Resistance to stress corrosion cracking for each lot of specimen shall be established by testing the previously astn tension-test samples for lot acceptance purposes. The material shall be supplied in the mill finish and shall conform by the requirements of this specification and shall be commercially sound.
Combining values from the two systems may result in non-conformance with the standard.
Variations from the specified diameter, length, and straightness shall not exceed the permissible variations prescribed. Link to Active This link will always route to the current Active version of the standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. For rolled or cold-finished wire and rod, see Specification Band for extruded wire and rod, see Specification B Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of wstm standard.
Samples for chemical analysis shall be taken from the material by drilling, sawing, milling, turning, or clipping a representative piece or pieces to obtain a prepared sample.
This abstract is a brief summary of the referenced standard. This specification covers wire and rod in the alloys and the tempers suitable for manufacturing rivets and other similar items by cold-heading operations. The products covered by this specification shall be produced by extruding, rolling, or drawing, or a combination thereof, at the option of the producer.